1/8 Pressure Dial

999 Aluminium Waste Support

The aluminium waste support work to ensure the cut quality of the Cassese 999 saw, this part will support the waste piece of moulding when a cut is made to prevent movement and chipping in the moulding. This part should be replaced as it becomes heavily...

Cassese 999 Square Cutting Block

This is a part that should be changed once it has become heavily worn, this part will prevent breakaway on the back of the mouldings when cutting and should be changed at the same time as the 999 aluminium finger waste support; as they work together to...

Short Belt (939)

This part is used on the blade bearing assembly, the belt is one of two used on each side of the cutting machine. When these belts become worn or slack the machine will be noisier when starting up and may also lose power if very loose. If they break the...

Black Tip

These rubber tips are used on the saws vertical clamps, they will often wear and can eventually cause marks on the moulding. When worn they will also not clamp as firmly so should be changed when signs of damage are present. This is for 1 x E-tip please...

Black Waste Support (969 Saw)

This part is used to support the waste piece of moulding between the mitre and will effect the cut of the machine if heavily worn. They are a simple part to change and can make a real difference to the quality of work. MFG: Z12615 Compatible with 969 Saw

Long Drive Belt (939 Saw)

These belts will wear over time, become slack, or damaged due to loose moulding and general wear. They should be checked for tension and damage then replaced if necessary. It is advisable to change these as a pair. MFG: Z1851 Compatible with 939 Saw

Black Tip (with Holder)

The rubber tips can become difficult to remove from the holder; often the holder will then become damaged. If this is the case the we would advise that you replace the whole part, making it easier to replace next time. MFG: Z16029 Compatible with all...

White Tip (Horizontal Clamp)

These white tips are found on the end of the horizontal clamping mechanisms. There are two per machine and they are important for effectively clamping and holding the moulding in position ready for cutting. MFG: Z2607

Waste Support (939)

This part holds the waste piece between the two mitres, it performs an important role of holding the waste piece secure during the cut; this ensures that the moulding cuts cleanly. If this part is excessively worn you should replace it to avoid a loss in...

Short Belt (969 & 999)

There are two blade drive belts used on the 969 saw, these should be replaced as a routinely maintenance of the machine as this will prevent them from fully breaking and putting the machine out of action. MFG:  Compatible with Cassese 969 & 999...