Created with Sketch. Created with Sketch.

Cassese 999

  • 999 Aluminium Waste Support

    The aluminium waste support work to ensure the cut quality of the Cassese 999 saw, this part will support the waste piece of moulding when a cut is made to prevent movement and chipping in the moulding. This part should be replaced as it becomes heavily...

    Add to Cart
  • Cassese 999 Square Cutting Block

    This is a part that should be changed once it has become heavily worn, this part will prevent breakaway on the back of the mouldings when cutting and should be changed at the same time as the 999 aluminium finger waste support; as they work together to...

    Add to Cart
  • Black Tip

    These rubber tips are used on the saws vertical clamps, they will often wear and can eventually cause marks on the moulding. When worn they will also not clamp as firmly so should be changed when signs of damage are present. This is for 1 x E-tip please...

    Add to Cart
  • Black Tip (with Holder)

    The rubber tips can become difficult to remove from the holder; often the holder will then become damaged. If this is the case the we would advise that you replace the whole part, making it easier to replace next time. MFG: Z16029 Compatible with all...

    Add to Cart
  • White Tip (Horizontal Clamp)

    These white tips are found on the end of the horizontal clamping mechanisms. There are two per machine and they are important for effectively clamping and holding the moulding in position ready for cutting. MFG: Z2607

    Add to Cart
  • Short Belt (969 & 999)

    There are two blade drive belts used on the 969 saw, these should be replaced as a routinely maintenance of the machine as this will prevent them from fully breaking and putting the machine out of action. MFG:  Compatible with Cassese 969 & 999...

    Add to Cart